ONE YEAR LIMITED WARRANTY
SI PRODUCTS sells its products with the intent that they are free of defects in manufacture and
workmanship for the life of the original purchaser from the date of original purchase, except as noted
below. SI PRODUCTS warrants that its products will be free of defects in material and workmanship
under normal use and service. This warranty extends only to consumers and does not extend to
Retailers.
To obtain warranty service on your SI PRODUCTS product, mail the product and your dated sales
receipt (as proof of purchase), postpaid, to the following address:
SI PRODUCTS Consumer Relations
Service Center Dept. 168
3000 Pontiac Trail
®
™
iPhone /iPod
Portable Speaker Dock
Commerce Township, MI 48390
No COD's will be accepted.
SI Products
Service Center
SI PRODUCTS does not authorize anyone, including, but not limited to, Retailers, the subsequent
consumer purchaser of the product from a Retailer or remote purchasers, to obligate SI PRODUCTS
in any way beyond the terms set forth herein. This warranty does not cover damage caused by
misuse or abuse; accident; the attachment of any unauthorized accessory; alteration to the product;
improper installation; unauthorized repairs or modifications; improper use of electrical/power supply;
loss of power; dropped product; malfunction or damage of an operating part from failure to provide
manufacturer’s recommended maintenance; transportation damage; theft; neglect; vandalism; or
environmental conditions; loss of use during the period the product is at a repair facility or otherwise
awaiting parts or repair; or any other conditions whatsoever that are beyond the control of SI
PRODUCTS.
This warranty is effective only if the product is purchased and operated in the country in which the
product is purchased. A product that requires modifications or adoption to enable it to operate in any
other country than the country for which it was designed, manufactured, approved and/or authorized,
or repair of products damaged by these modifications is not covered under this warranty.
THE WARRANTY PROVIDED HEREIN SHALL BE THE SOLE AND EXCLUSIVE WARRANTY. THERE
SHALL BE NO OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS OR ANY OTHER OBLIGATION ON THE PART OF THE COMPANY WITH
RESPECT TO PRODUCTS COVERED BY THIS WARRANTY. SI PRODUCTS SHALL HAVE NO LIABILITY FOR
ANY INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES. IN NO EVENT SHALL THIS WARRANTY
REQUIRE MORE THAN THE REPAIR OR REPLACEMENT OF ANY PART OR PARTS WHICH ARE FOUND TO
BE DEFECTIVE WITHIN THE EFFECTIVE PERIOD OF THE WARRANTY.
1.888.856.6781
8:30a.m. – 7:00p.m. (EST)
M – F
Mail To: SI Products
Consumer Relations
Service Center Dept. 168
3000 Pontiac Trail
Commerce Township, MI
48390
e-mail:
NO REFUNDS WILL BE GIVEN. IF REPLACEMENT PARTS FOR DEFECTIVE MATERIALS ARE NOT
AVAILABLE, SI PRODUCTS RESERVES THE RIGHT TO MAKE PRODUCT SUBSTITUTIONS IN LIEU OF
REPAIR OR REPLACEMENT.
This warranty does not extend to the purchase of opened, used, repaired, repackaged and/or resealed
products, including but not limited to sale of such products on Internet auction sites and/or sales of
such products by surplus or bulk resellers. Any and all warranties or guarantees shall immediately
cease and terminate as to any products or parts thereof which are repaired, replaced, altered, or
modified, without the prior express and written consent of SI PRODUCTS.
This warranty provides you with specific legal rights. You may have additional rights which may vary
from state to state. Because of individual regulations, some of the above limitations and exclusions
may not apply to you.
For service or repair - do not return this unit to the retailer.
Contact SI PRODUCTS Consumer Relations at 1-888-856-6781.
©The Sharper Image. All rights reserved. THE SHARPER IMAGE name and logo are registered
trademarks.
Instruction Manual and
Warranty Information
EC-P115
©2009 THE SHARPER IMAGE and its affiliated companies, all rights reserved. THE SHARPER IMAGE is a
registered trademark of THE SHARPER IMAGE and its affiliated companies. All rights reserved.
iPod®, iPod and the iPod® design are trademarks of Apple Inc.
IB-ECP115
Main Features:
• Perfect for travel
• Compact design folds down for easy storage
• Handy zipper travel case included
• iPod/iPhone docking and charging display
• Dual Alarm Clock and Snooze features
• Features Nap function with 15, 30, 45, 60 minutes
• Digital Volume
• Uses AC Adaptor (5V / 1.2 A) (included)
• Powered by 4 (four) ‘AA’ batteries (not included)
Fig. 1
(iPhone not included)
Battery Installation:
This unit uses an AC adaptor (5V/1.2 A) (included) or optional 4 (four) AA batteries
(not included).
Volume Controls
Battery Precautions
• Use only the size and type of batteries specified.
• When installing batteries, observe proper +/- polarities. Incorrect installation of
battery may cause damage to the unit.
• Do not mix different types of batteries together (e.g., alkaline with carbon-zinc
or old batteries with new ones).
• If the unit is not going to be used for a long period of time, remove batteries to
prevent damage due to possible battery leakage.
Snooze Controls
• Do not dispose of batteries in fire. Batteries may explode or leak.
Alarm Setting
Function
(Underneath)
Dimmer Button
Power Button
5
4
Setting the Time
1. Press the HOUR button located on the bottom of the unit, hour digits will
begin flashing. Press the and buttons to select the current hour. Press
HOUR button again to exit the hour setting mode OR after 10 seconds the
display will stop flashing to indicate the hour is set.
2. Press the MINUTE button located on the bottom of the unit, minute digits will
begin flashing. Press the and buttons to select the current minute. Press
MINUTE button again to exit the minute setting mode OR after 10 seconds
the display will stop flashing to indicate the minute is set.
Getting Started
Listening to your iPhone/iPod:
Setting the Alarm
1. Press the power button on the top of unit to turn ON.
2. Fit iPod/iPhone carefully into dock, docking connector should easily match
with socket on your iPod/iPhone.
For your convenience, two separate alarms may be set:
Alarm 1 button
Note: Do not force. Carefully slide iPod/iPhone over dock connector to
avoid damage.
1. Press the al 1 button on the bottom of the unit. The al 1 icon will appear on
the LCD display to indicate the alarm1 is activated.
WARNING: DOCKING CONNECTOR IS DESIGNED FOR APPLE iPOD/
iPHONE MUSIC PLAYERS ONLY. ATTEMPTING TO ATTACH OR FORCE ANY
NON-iPOD/iPHONE MUSIC PLAYER INTO THE DOCKING CONNECTOR
WILL DAMAGE AND EVEN DESTROY YOUR DEVICE.
3. Press the play/pause ( ) button on your iPod/iPhone to play, press again
to pause. The iPod icon will appear on the LCD display to indicate the iPod
mode has been selected.
2. Press and hold the al 1 button for 3 seconds, hour digits will begin flashing.
Press the and buttons to select the desired hour.
3. Press the al 1 button again, minute digits will begin flashing. Press the and
buttons to select your desired minutes.
4. Press the al 1 button for the third time to exit the alarm setting mode or after 5
seconds the display will stop flashing to indicate the alarm is set.
5. Press the “al mode” button on the bottom of the unit until the wake mode
icon appears on the LCD display to indicate the wake mode of your choice:
iPod or beep tone.
6. Press the al 1 button on the bottom of the unit again to deactivate the al 1.
The al 1 icon will disappear from the display.
4. Press the
or
on your iPod/iPhone to go to the next or previous track.
5. Press the and on the unit to adjust the volume.
Note: Your iPod/iPhone will charge even if the POWER button is turned off.
The unit only needs to be plugged in for the iPod/iPhone to charge.
6
7
Alarm 2 button
Dimmer Control
1. Press the al 2 button on the bottom of the unit. The al 2 icon will appear on
the LCD display to indicate the alarm2 is activated.
Press the dimmer button located on top of the unit to adjust the backlight
intensity of the LCD display from hi-low-off.
2. Press and hold the al 2 button for 3 seconds, hour digits will begin flashing.
Press the and buttons to select the desired hour.
3. Press the al 2 button again, minute digits will begin flashing. Press the and
buttons to select your desired minutes.
Snooze Operation
Press the snooze/nap/sleep bar on top of the unit while the alarm is sounding.
The alarm will be silenced and return 9 minutes later. Snooze can be pressed
several times during the 1 hour alarm cycle. You may use this feature until you turn
the alarm OFF.
4. Press the al 2 button for the third time to exit the alarm setting mode or after 5
seconds the display will stop flashing to indicate the alarm is set.
5. Press the “al mode” button until the wake mode icon appears on the LCD
display to indicate the wake mode of your choice: iPod or beep tone.
6. Press the al 2 button on the bottom of the unit again to deactivate the al 2.
The al 2 icon will disappear from the display.
Nap Operation
The Nap function will wake you after a nap of 15, 30, 45 or 60 minutes – without
the need to change your regular al 1 or al 2 settings.
1. If the system is playing audio, press the power button to turn OFF.
2. Toggle through the snooze/nap/sleep bar to the corresponding time of your
choice: 15, 30, 45 or 60 minutes – as it will show on the LCD display.
3. Toggle through the “al mode” button on the bottom of the unit until the
corresponding wake mode (iPod or beep) icon of your choice lights up on the
LCD display. The alarm bell ( ) icon will show next to the selected mode.
4. The alarm will sound to wake you up after the selected number of minutes has
passed.
5. To cancel the Nap timer, press the snooze/nap/sleep bar until OFF shows
on the LCD display, which indicates the Nap function is disarmed.
8
9
Sleep Timer Operation
Maintenance
The Sleep timer will let your audio selection play for 15, 30, 45 or 60 minutes –
without the need to change your regular al 1 or al 2 settings.
1. With audio playing, press the snooze/nap/sleep bar on top of the unit
repeatedly to cycle through the sleep time options of 15, 30, 45, 60 minutes
or OFF.
To Store
You may leave the unit on display, or you can store it in its box
in a cool, dry place.
To Clean
Use only a soft dry cloth to clean the enclosure of the unit.
2. After setting the sleep time, the music will continue to play for the time that
you selected and then automatically shut off.
NEVER use liquids or abrasive cleaner to clean.
Modifications not authorized by the manufacturer may void user warranty.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
10
11
|