13) Unplug this apparatus during lightning storms or when
unused for long periods of time.
Owner’s Record
Power sources
The model number and the serial number are located on the
bottom.
4-182-698-13(2)
14) Refer all servicing to qualified service personnel. Servicing
is required when the apparatus has been damaged in any
way, such as power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the apparatus,
the apparatus has been exposed to rain or moisture, does
not operate normally, or has been dropped.
Record the serial number in the space provided below. Refer to
them whenever you call upon your Sony dealer regarding this
product.
Notes
When the battery becomes almost fully depleted, “LOW
BATT” flashes and the unit will turn off. To charge the
battery, connect the AC power adaptor. ( See “Preparing
a power source.”)
• Charge a new battery pack before use. See “Preparing a power
Preparing a power source
source” for details.
Model No. RDP-XF100iP
• Turn off the unit, before replacing the rechargeable battery pack.
• When replacing the rechargeable battery pack, place a soft cloth,
etc., under the unit.
Charge the rechargeable battery before using this unit for
the first time, or when the battery is depleted. You can
operate the unit while charging.
Serial No. _______________________________
For the state of california, USA only
Perchlorate Material –special handling may apply, see
For customers in the USA
Please register this product on line at
1 Connect the AC power cord (supplied) to the AC
power adaptor (supplied).
Perchlorate Material: Lithium battery contains perchlorate
Proper registration will enable us to send you
periodic mailings about new products, services,
and other important announcements. Registering
your product will also allow us to contact you in
the unlikely event that the product needs
adjustment or modification. Thank you.
Preparing the remote
commander
2 Connect the AC power adaptor to the DC IN 20V
jack on the back of this unit firmly and plug it into a
wall outlet.
Notes
RECYCLING NICKEL METAL HYDRIDE
BATTERIES
Nickel Metal Hydride batteries are
recyclable. You can help preserve our
environment by returning your used
rechargeable batteries to the collection
and recycling location nearest you.
• The remaining battery power will not be indicated when the unit is
turned off.
Before using the remote commander for the first time,
remove the insulation film.
• The unit requires at least 30 minutes to charge the battery if “LOW
BATT” appears.
• The battery indicator shows approximate remaining battery power.
• Operating conditions will affect the rate of battery depletion.
Personal Audio
Docking System
Battery life
When
Playback of iPod
FM reception
WARNING
To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture.
AUDIO IN
DC IN 20V
Battery life
approx. 7hours*
approx. 7hours
For more information regarding recycling of rechargeable
batteries, call toll free 1-800-822-8837 or visit
To know when to replace the battery
With normal use, the battery (CR2025) should last for
about 6 months. When the remote commander no longer
operates the unit, replace the battery with a new one.
Caution: Do not handle damaged or leaking Nickel Metal
To reduce the risk of fire, do not cover the ventilation of
the apparatus with newspapers, tablecloths, curtains, etc.
And do not place lighted candles on the apparatus.
Measured in accordance with the JEITA (Japan
Electronics and Information Technology Industries
Hydride batteries.
Association) standard.
The validity of the CE marking is restricted to only those
countries where it is legally enforced, mainly in the countries
EEA (European Economic Area).
* Playback time measured using a fully charged rechargeable battery
with a fully charged iPod classic.
To reduce the risk of fire or electric shock, do not expose
this apparatus to dripping or splashing, and do not place
objects filled with liquids, such as vases, on the
apparatus.
To wall
outlet
When to replace the rechargeable
Disposal of Old Electrical & Electronic
Equipment (Applicable in the European
Union and other European countries
with separate collection systems)
battery pack
Do not install the appliance in a confined space, such as a
bookcase or built-in cabinet.
AC power
adaptor
AC power
cord
Repeated recharging causes the capacity of the
rechargeable battery power to decrease over time. Replace
the rechargeable battery pack when its capacity becomes
half the usual time, even after charging the battery fully.
CR2025
Do not expose the batteries (battery pack or batteries
installed) to excessive heat such as sunshine, fire or the
like for a long time.
Note on the AC power adaptor
• Use the Sony supplied AC power adaptor only. The polarity of the
plugs of other manufactures may be different. Failure to use the
supplied AC power adaptor may cause the unit to malfunction.
Note
• The rechargeable battery pack is not a commercially available
product. To purchase a rechargeable battery pack (NH - 2000 RDP),
consult with your nearest Sony dealer.
As the main plug is used to disconnect the unit from the
mains, connect the unit to an easily accessible AC outlet.
Should you notice an abnormality in the unit, disconnect
the main plug from the AC outlet immediately.
Features
• Compatible with iPod®/iPhone®
• FM tuner with 20 station presets
• Rechargeable battery for portable use
• Audio in function
Notes
• Do not attempt to charge the battery.
• If you are not going to use the remote commander for a long time,
remove the battery to avoid any damage that may be caused by
leakage and corrosion.
3 Confirm that charging has started.
When charging start, the battery indicator appears.
While charging, the charging indicator animation
loops.
The unit is not disconnected from the AC power source
(mains) as long as it is connected to the wall outlet, even
if the unit itself has been turned off.
Replacing the rechargeable
battery pack
1 Slide the latch to UNLOCK, and slide RELEASE in
the direction of the arrow on the bottom of this unit.
The battery compartment cover opens, then remove
the cover.
The nameplate and important information concerning
safety are located on the bottom exterior of main unit
and on the surface of AC power adaptor.
Operating Instructions
RDP-XF100iP
• Wireless remote commander supplied
When the unit is turned off
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.
Precautions
• Play the unit on the power source specified in
“Specifications.”
• To disconnect the AC power cord (mains lead), pull it
out by the plug, not the cord.
• Since a strong magnet is used for the speaker, keep
personal credit cards using magnetic coding or spring-
wound watches away from the unit to prevent possible
damage from the magnet.
• Do not leave the unit in a location near a heat source
such as a radiator or airduct, or in a place subject to
direct sunlight, excessive dust, mechanical vibration, or
shock.
• Allow adequate air circulation to prevent internal heat
build-up. Do not place the unit on a surface (a rug, a
blanket, etc.) or near materials (a curtain) which might
block the ventilation holes.
• Should any solid object or liquid fall into the unit,
unplug the unit and have it checked by qualified
personnel before operating it any further.
2 Use a coin, etc., to pull out the rechargeable battery
When charging completes, the full battery indicator
appears for a while, and then disappears.
pack.
3
Remove the rechargeable battery pack and disconnect
the lead from the jack inside the battery compartment.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same type.
©2010 Sony Corporation
Printed in China
4 Connect the lead of a new rechargeable battery pack
to the jack and insert the battery in the unit.
Notes
NOTE
5 Close the battery compartment cover and slide the
• If you connect the AC power adaptor when the battery is fully
charged, the full battery indicator appears for a while, and then
disappears.
• If you connect the AC power adaptor when the battery power is low,
charging starts and the low battery and charging indicator
animation loops.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
latch to LOCK.
The unit cannot perform operations without the AC
power adaptor while the low battery indicator
appears.
– Reorient or relocate the receiving antenna.
1
2
• To clean the casing, use a soft cloth dampened with a
mild detergent solution.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for
help.
When the unit is turned on
NOTES ON LITHIUM BATTERY
• Wipe the battery with a dry cloth to assure a good
contact.
• Be sure to observe the correct polarity when installing
the battery.
WARNING
• Replace the battery for the remote commander with a
Sony CR2025 lithium battery. Use of another battery
may present a risk of fire or explosion.
• Battery may explode if mistreated. Do not recharge,
disassemble or dispose of in fire.
When charging completes, the full battery indicator
appears.
• Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
If you have any questions or problems concerning your
unit, please consult your nearest Sony dealer.
• Dispose of used battery promptly. Keep away from
children.
Note
• It will take approximately 7 hours to charge the battery.
Important Safety Instructions
1) Read these instructions.
3
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
Using the rechargeable
battery
You can operate the unit with the rechargeable battery
instead of the AC power adaptor.
7) Do not block any ventilation openings.
Note
Install in accordance with the manufacturer’s instructions.
• The maximum output will be lower when the AC power adaptor is
8) Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers)
that produce heat.
9) Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug has
two blades and a third grounding prong. The wide blade
or the third prong are provided for your safety. If the
provided plug does not fit into your outlet, consult an
electrician for replacement of the obsolete outlet.
disconnected.
4
5
To check the remaining power of the
battery
The remaining power of the battery will be indicated
when the unit is turned on. As the remaining battery
power depletes, the battery indicator decreases.
10) Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
11) Only use attachments/accessories specified by the
manufacturer.
Level 1
Level 2
Level 3
Level 4
12) Use only with the cart, stand, tripod, bracket, or table
specified by the manufacturer, or sold with the apparatus.
When a cart is used, use caution when moving the
cart/apparatus combination to avoid injury from tip-over.
|